The bird feeder does not require complex design solutions. And its constituent parts can be from the most elementary materials lying around at home. These can be beverage bottles, milk or candy boxes, etc. And most importantly, the time for all the work will be spent as short as possible! The gazebo feeder, installed on the surface, is made as follows:
Instructions
Step 1
Take four legs (about 150 cm long) and fasten them at the bottom with crossbars around the entire perimeter. Next, connect two opposite crossbars with a board or bar (10cm). The central post will be attached to this bar;
Step 2
Place one feeder in the middle on the center post and one under the roof of the feeder. The lower one is for large birds, and the upper one is for small ones;
Step 3
Tap the perimeter of the feeder tray. Then install a four-pitched trough roof to keep out snow and rain.
